Ram the claw into the nail shank as close as possible to the wood and rock it sideways (Photo 1). Then repeat the process, pulling the nail about 1/2 in. each time. You develop terrific pulling power, enough to extract even those tough cement-coated or galvanized nails, without straining your hammer handle or arm.
Scrub the piece with soap and water. Put a teaspoon of dish soap in a bucket of water. Using a soft bristle scrubber, wash all the oven cleaner and former finish residue from the wood. Rinse the piece with clean water. Using your water hose, spray off all the soap and other residue from the piece.
That process is called rubbing out. Rubbing out is nothing more than abrading the surface until it’s nice and smooth. Take it to a high enough grit and you’ll be polishing the surface to a super high gloss. Stop sooner at a lower grit and you can achieve the perfect semi-gloss, satin, or matte finish. The key to this process is letting the
Reduce the humidity in the spraying room to 50 percent or less with a dehumidifier before you spray. Sand the finish lightly with 220-grit sandpaper, wipe off the sanding dust with a rag and spray a full wet coat. When the coat dries, the blushing should be gone. If it isn't, add a retarder to the mixture to slow the drying time.
Step Five. After the paint was scraped off, I had a light gummy residue left on the table. With my gloves back on, I poured Mineral Spirits onto the clean scrap rag and lightly scrubbed the residue off. The Stripping Pad, scrap cloth, and Mineral Spirits I use for stripping paint from wood furniture.
Sep 11, 2013. #2. Depends on what type of finish it is. You can use paint/finish remover on lacquer (s) to get the job done faster and lose less wood (usually still requires fine sanding) If it is a polyester finish like on MIM fenders the only way it will come off is sandpaper. Sent from my GT-P3113 using Tapatalk 4.
How do you remove a lacquer stain from kitchen cabinets? Lynette Trejo Answered on Aug 22, 2017 I hired a painter to stain my oak cabinets a darker stain, not wanting to paint them.
Wipe with a cloth following the grain of the wood, then rinse the spirits off. The spirits will soak into the wood and remove penetrated stains. Oxalic acid: For darker, tougher water stains, mix 1 part oxalic acid with 6 parts water. Put on gloves and scrub the stains with a cloth and your acid mixture.
If that doesn’t work, she uses Citristrip’s paint and varnish stripping gel ($12.98 a quart at Home Depot), which removes many finishes, including paint, varnish, polyurethane, lacquer and
Solvent paint strippers break down the bond between the paint and the surface. They effectively remove paint, epoxy, and polyurethane from a variety of surfaces, including wood, masonry, and metal. Though effective, they contain harmful chemicals, such as methylene chloride and N-methyl-2-pyrrolidone, that pose serious health risks. Caustic
PRixz4z. how to remove finish from wood
